Af clo5e box

[Psychedelicropcircle]

Hi folks anybody using or recommend using 1st gear shims that are below 1mm?

Have the two under rear bearing shims in. Thick & thin! Suppose I could pull it all apart & put the double thick shims under the rear bearing. Thoughts team?

Save me from a new east to fit cyclone box please

[Psychedelicropcircle]

Update two x thick shim & 1x thin shim under rear bearing. Still too much for a 1mm shim.

Using an MB layshaft.

Anybody with the same setup?

Euro fast approaching

[hullygully]

some cyclone shims are less than 1mm bud

[steveg]

AF do or at least did shims at various thicknesses under 1mm, worth calling them maybe

[hullygully]

check the rear hub bearing's thickness dimensions against an old Innocenti one, I had a good 0.5mm differance on one bearing to std

[hullygully]

AF do or at least did shims at various thicknesses under 1mm, worth calling them maybe

be careful with some of the AF's gear shims as they're not the same thickness in 4 x different positions on the outside diameter
I'd use cyclone or Broady

[Psychedelicropcircle]

When you say gear shims do you mean the the first gear shim or the wire under the bearing type?

[bolzenanker]

I think Cyclone shims go down to 0.8mm, but I thought the AF box required a shim of between 1.4 and 2.4mm? (Could be wrong, going from memory.)

[hullygully]

When you say gear shims do you mean the the first gear shim or the wire under the bearing type?

1st gear shim bud