TS1 with left hand inlet manifold

[a-teamlambretta]

Anyone using a left hand inlet manifold on a TS1 cylinder?. I don't want to hack the battery tray off my series 1. Is there enough clearance ect ?.

Cheers Simon.

[Knowledge]

Sticky has one on his TS1 240 and Superhooper on here has one too on his pretty standard TS1 225.

Both engines are good.

[Storkfoot]

viewtopic.php?f=7&t=15059&p=140127&hilit=Linke+nummer#p140127

[jonoy]

I have a LTH left side manifold on my TS 1 on my GP
All good

[superhooper]

Used offset cones to give more clearance. All good
Regards Super

[Norrie Bodge]

I have a LTH left side manifold on my TS 1 on my GP
All good

+1
Using a skimmed reed block (by half) & 3mm reed packer
no issues

[a-teamlambretta]

Thanks to all for the info... will get one ordered.

Cheers Simon.

[Leotech]

Again see other TS1 exhaust post, I also asked Ben about a left hand manifold as my bike is UK from new with a battery tray which I don't wish to hack off, He said same as he did about the box pipes and PHBH carbs.


With a PHBH and an Avanti type box pipe the left hand manifold is not noticeable, But if you go for full on flat slide and a high revving expansion pipe etc, you will notice a drop in performance.

[a-teamlambretta]

I have just ordered this one from sip
https://www.sip-scootershop.com/en/prod ... m_40821200

[Leotech]

I should have said AF Ben has them in stock.

[al pushpak]

will one of these fit a Monza 225? cheers

[a-teamlambretta]

will one of these fit a Monza 225? cheers

Yes ...I was using an imola manifold on the ts1 prior to going left hand manifold.

Cheers Simon

[al pushpak]

cheers