Pm 25evo exhaust

[Marrsy7]

Hi all has anyone got or used a pm25 evo exhaust looking at buying one just wondering about fit , quality etc . Be going onto a mugello 186

[Storkfoot]

Many years back, I ran a PM25 on a Mugello 186. I found it a bit all or nothing and longed to go back to the old AF Clubman I had on before. Also, it’s a heavy exhaust without a stub manifold. I found it quite hard to get a good seal and ended up stripping the thread in the alloy barrel.

[Toddy]

Many years back, I ran a PM25 on a Mugello 186. I found it a bit all or nothing and longed to go back to the old AF Clubman I had on before. Also, it’s a heavy exhaust without a stub manifold. I found it quite hard to get a good seal and ended up stripping the thread in the alloy barrel.

Similar to you paul found it heavy when I ran one on a TS and with no rear end can support found it tended to shake loose and take the studs out, if I remember correctly it performed well with the TS being a good all round pipe

[jonw]

I run the Evo version on my GT 186, makes good power at just over 20hp, revs on well but not too peaky with a decent spread of power. I've not found it to be any heavier than any other exhaust?? I also visually like the fact that the muffler doesn't stick out a mile behind the scoot like most do. Quality is good but access when fitting the manifold is very tight which is the only downside to it.

[Marrsy7]

Thanks for reply’s think I’ll look at an nk or something else