Casing Welding Recommendations
Posted: Wed Feb 12, 2020 10:03 amAny one got any recommendations... looking for someone who can complete a casing repair on Spanish 200 casing... got a crack running from oil seal stud hole through to chaincase
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://ilambretta.co.uk/forum/
Casing Welding Recommendations
Page 1 of 1
Posted: Wed Feb 12, 2020 10:03 amRe: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 10:35 amMB...
Re: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 11:55 am+1
Re: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 3:40 pmMark Broadhurst did mine top job
Re: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 8:50 pmThanks for replies... contacted Mark... not repairable because of potential warpage
Re: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 9:21 pmI bought a 200 Sil casing from Scooter Restorations a few years ago that was being sold as damage repairable, one of the bearing drive plate screw threads had been tapped in too far & broke through into the chain case side, it had already been ali welded when I purchased it, I still run this engine now & fingers X have not had any issues so far, I know MB's are good & know their stuff but maybe contact some other places such as Oiltek or CS Engineering before deciding what to do next . Good luck 
Re: Casing Welding Recommendations
Posted: Wed Feb 12, 2020 9:25 pmPity, I had 4 sets of Jet200 engines that needed some sort of welding sorting out, Mb sorted out 3 of them but the last set proved too far gone in the end plate section so now being used as a door stopper 
Re: Casing Welding Recommendations
Posted: Thu Feb 13, 2020 10:44 pmShane I'm intrigued... garage door I imagine? 
Re: Casing Welding Recommendations
Posted: Fri Feb 14, 2020 3:09 amAndy B.L.C. wrote:Shane I'm intrigued... garage door I imagine?
Aye Andy, the batcave as I call it