Page 1 of 1
RD 350 levers
Posted:
Sat Jan 27, 2018 9:27 pmby Andy B.L.C.
Got the right year.
Tried finding relevant thread.
Got distracted by Craig Charles show...
Is it just the housing that needs fettling or am I better taking a bit off the lever n all?
Ta up front!
Re: RD 350 levers
Posted:
Sat Jan 27, 2018 9:39 pmby Solid Air
He's good that Craig Charles fella isn't he Andy
haven't done it myself but I think I'd rather fettle the lever, less of a problem if it doesn't go quite right
Re: RD 350 levers
Posted:
Sat Jan 27, 2018 10:11 pmby Knowledge
I must admit, I have always modified the housing, but that me all over: Living life on the edge.
Have a look at the photo on the MB website: you can almost cut a cardboard template from it.
Re: RD 350 levers
Posted:
Sun Jan 28, 2018 3:10 amby Fast n Furious
I use modified Yammy SR125 levers. Its important to make sure that when pulling your choice of lever in.....that only the cable nipple is in contact with lever. If the inner cable touches the radius of the lever it will place stress here and it will probably snap within 500 miles. ( speaking from experience here).
Dont know if this is an issue with RD levers.