LCGB Forums

I want to fit an ignition switch to my late S2 instead of the cut out. I have a Beedspeed elec loom, 3 wire. Has anybody done this and any advise before I file the headset?

I did it on my indian s2 - hardly had to file anything out - just offer it up and take your time

I had to rework some of the wiring but it was nt difficult from memory.

As Gaz says it should fit almost straight in, scootopia one tend to be a little bigger. You only need to wire up the green wire to use the switch for security.

I found the switch itself to be thick steel and I filed /ground the switch rather than the housing, also some have a very thick rubber cover that all add to the bulk on the rear size, the hole at the front is the easy bit

Thanks guys for the links and information. Very helpful.