Page 1 of 1

drive train

PostPosted: Thu Nov 12, 2026 10:35 pm
by blumanc
currently rebuilding a series 2 125 ,186kit, clubman pipe, 22mm carb , the crown wheel is the sprung type, so I am replacing that any other modifications recommended in the gearing/drive train dept

Re: drive train

PostPosted: Fri Nov 13, 2026 11:02 pm
by gaz_powell
I've just build a Scootopia 185, with 26mm phbh and scootopia clubman

Used a MEC crown, front sprocket and chain.
Genuine SIL spider and bell.
Standard bronze bush... Not brass
4 plate Surflex B clutch plates, AF GT springs.
Genuine SIL drive parts
Scooter Restorations nylon top chain guide and trimmed lower guide.
INA bearings on cluster and layshaft

Make sure to shim the gearbox correctly and align chain.

All good quality at good price, fitted first time no issues.

Clutch easily copes, and is nice in operation.

Lovely to ride but a bit slow.... So coming out soon

Same set up in my TS1s... No issues

Re: drive train

PostPosted: Sat Nov 14, 2026 10:50 am
by blumanc
thanks for that, did you stick with the standard ratios ?

Re: drive train

PostPosted: Sun Nov 15, 2026 11:13 am
by gaz_powell
Yes on 185, Italian LI 150 with standard sprockets 15*46, as using a box pipe